Uniden DSS 2475 User Manual
Page 51
[ 45 ]
Setting the Time
Follow these steps to set the clock on the answering system to the correct time.
1) Press .
2) Press
/SELECT
or
/SELECT
until the correct day is announced and the
corresponding number (from “
” Sunday to “
” Saturday) appears.
3) Press
to select the day.
4) Press
/SELECT
or
/SELECT
until you hear the correct hour setting.
The numbers “
” through “
” appear on the base as each hour is announced.
5) Press
to select the hour.
6) Press
/SELECT
or
/SELECT
until you hear the correct minute setting.
The numbers “
” through “
” appears on the base as each minute is announced.
7) Press
to select the minute.
8) Press
/SELECT
or
/SELECT
until you hear the correct AM or PM setting.
The message counter displays “
” or “
”.
9) Press
to select the AM/PM setting.
A confirmation tone sounds, the day and time you set are announced for your review.
Setting a PIN code
To play your messages from a remote location, you will need to enter a two-digit
Personal Identification Number (PIN) code (
-
). To select a PIN code, perform
the following steps:
1) Press
twice. The current PIN code appears on the base
and it is announced.
2) Press
/SELECT
or
/SELECT
until the desired number appears. Press and hold
/SELECT
or
/SELECT
to quickly scroll through the numbers on the display.
3) Press
to select the PIN code.
A confirmation tone sounds, the system announces the new PIN code.
• Normally, if the
system remains idle
for 10 seconds after
/SELECT
or
/SELECT
is
pressed, the system
will return to
standby. However, for
setting the time, the
idle time is extended
to 2 minutes.
• Press and hold
/SELECT
or
/SELECT
to
quickly scroll through
the numbers on
the display.
• Time stamp will not
be heard until you
have set the time.
UP308BH (DSS2465) ENG OM 12/28/04 8:26 AM Page 45