Universal Laser Systems CLP-100NI-NPRT - Manual (Page 15)

15
QUICK START
FOR MOUNTING INSTRUCTIONS
REFER TO THE APPROPRIATE SECTION
FOR YOUR APPLICATION
WEB PRINTING - PAGE 19
CARTON PRINTING - PAGE 23
ADJUSTING THE INK ROLL ECCENTRIC
As soon as you can see complete ink coverage on the die faces,
stop rotating the eccentric. Proper adjustment will normally be
reached when the reference line on the Eccentric is somewhere
between the 2 and 3 dial position.
This adjustment procedure brings the Ink Roller into contact with the surface of the Transfer Roller which in turn
applies the ink to the face of the printing dies. Do not rotate the Ink Roll Eccentric Knob further than necessary
towards the “MAX” position or the excess contact pressure will squeeze ink out of the ink roll and may cause
dripping inside the cover.
1 - After the printing dies are installed on the print drum, manu-
ally rotate the print drum continuously in one direction while
slowly rotating the Ink Roll Eccentric Adjusting Knob “I” from
the “MIN” position towards the “MAX” position. Turn the
Eccentric Knob in small increments and observe the face
of the Printing Dies “P” for signs of ink between each ad-
justment.
FIGURE 28