Ultratec 50DX20B - Manual (Page 25)

25
USING THE REMOTE TO CONTROL VCR FUNCTIONS
NOTES:
1. If your VCR cannot be operated after performing the above procedures, your VCR’s code has not been precoded into the
remote.
2. In the unlikely event that your VCR cannot be operated after performing the above procedures, please consult your VCR
operating guide.
3. The remote control will remember the codes you have programmed until the batteries are removed from the remote control.
After replacing the batteries repeat the entire programming procedure as stated above.
4. The INPUT button will act as your VCR ‘100’ button if required.
NOTE: Refer to instruction manual of the VCR for operation of the buttons exclusively for the VCR.
Operating the precoded function for your VCR.
This remote is designed to operate different types of VCRs. You must first program the remote to match the remote system of your
VCR. (refer to page 28)
1. Turn ON your VCR.
2. Aim the remote control at the front of your VCR.
3. Press the DVD/VCR button to switch to the VCR pre-coded mode.
4. Hold down the DVD/VCR button on the remote, enter the two digit preset code that matches your VCR as shown on page 28.
The remote will turn off your VCR when the correct two digit preset code is entered. When this occurs, the remote control is
programmed for your VCR. If the VCR does not turn off after five seconds, try a different two digit preset code.
5. The remote will now control your VCR.
PRECODED VCR BUTTONS
These buttons always transmit
the chosen precoded VCR codes.
1 2 3
4 5 6
7 8 9
0
INPUT STATUS
VOL CH
POWER
TV CBL/SAT DVD/VCR
PIP
SWAP MOVE
FREEZE
HELP MENU
MUTE
EXIT
LAST CH
REC TV/VCR PIX
SELECT
PIP CH
EXCLUSIVE TV Buttons
These buttons are for
operating the TV.
VCR button
This button allows the remote to
control your VCR by setting it to
VCR mode.