U-Line 2275DWRW - Manual (Page 9)

U-Line Drawer Alignment 7
Minor Adjustment:
Note: The mounting holes on the
slide are slightly larger than the
screws’ diameter.
1. Loosen one slide’s mounting
screws.
2. Level the slide.
3. Retighten the screws. See
Figure 18.
4. Repeat procedure for the
other slide.
Severe Adjustment:
Note: The slides have extra mounting holes that may be used.
1. Loosen one slide’s rear
mounting screws.
2. Remove the slide’s front
mounting screws.
3. Reposition the slide so it is
level.
4. Mark new front drilling holes
using a different set of
mounting holes on the slide.
5. Drill the new holes with a #30 drill bit.
6. Remount the slide.
7. Repeat procedure for the other slide.
Top-to-Bottom (and Left-to-Right) Adjustment
The drawer will need a Top-to-Bottom Adjustment if, when viewed
from the front, the drawer is not level horizontally. Viewed from
the top, one side will protrude. This is caused by one of the slides
being mounted higher than the other slide on the unit’s liner.
Minor Adjustment:
Note: The mounting holes on the slide are slightly larger than the
screws’ diameter.
1. Loosen one slide’s mounting
screws.
2. Push the slide upward or
downward to match the
position of the other slide.
3. Retighten the screws.
4. Repeat the procedure with
the other slide if necessary.
Severe Adjustment:
Note: The slides have extra mounting holes that may be used.
1. Remove one slide’s mounting
screws.
2. Reposition the slide so it is
the same distance from the
bottom of the liner as the
other slide. Measure to
confirm.
3. Mark new drilling holes using
different sets of mounting
holes on the slide. See Figure
22.
Note: Front location holes are shown. Corresponding rear holes
will also need to be marked.
4. Drill all the new holes with a #30 drill bit.
5. Remount the slide.
Re-installation of Drawer
CAUTION
Use care when handling the drawer. Drawer edges, drawer
rail and the unit’s slide may be sharp.
1. Set the drawer’s rails onto the slides.
2. Re-install the rails’ mounting screws. See Figure 13 on Page 10.
3. Plug in the drawer’s connection wiring (top drawer only).
Screws Should
Be Loose
Level the Slide
Mark and Drill New
Mounting Holes
Level the Slide
Not Aligned Left-to-Right
Top View of Unit Front View of Unit
Not Aligned
Top-to-Bottom
Push Slide
Upward or
Downward
Mounting Screws
Mark and Drill New
Mounting Holes
Push Slide
Upward or
Downward