Uniden BC 278CLT - Manual (Page 15)

12
Programming Scanner Frequencies
Before you can use your BC278CLT scanner, you must program the channels (except weather
and service frequencies). Follow these steps:
Example: Program 420.150 MHz into Channel 12.
1. Press MANUAL to stop scanning.
2. To select the channel (12),
press 1, then 2 on the
numeric keypad. Then press
MANUAL again.
OR
Press ▼/▲ until channel
12 appears in the display.
3. Type in the frequency numbers, including the
decimal point, using the numeric keypad: 420.0150.
Channel digits flash as you make entry.
If you enter the number which cannot receive the
signals, the scanner automatically set the nearest
effective frequency number.
BC278clt.qxd 3/8/00 7:34 PM Page 12