Ultra electronic MAGICARD 300plus - Manual (Page 12)

Quick Start Guide Ultra Electronics Card Systems
Page 12 MAGICARD Color Printer
Flex a stack of plastic cards, to make sure
they are not 'stuck' together. Avoid
touching the surfaces to be printed.
Remove the 'tacky' roller before each
batch of 100 cards, by putting your
fingers beneath it and "snapping" out the
left hand end of the roller. Remove
surface dust by using a strip of 'Scotch'
adhesive tape, and "snap" back into
place.
Drop the cards flat down into the plastic
Cassette, side to be printed uppermost,
mag stripe to the left and facing down (if
used).
Load the
Plastic Cards
E
1
3a
2
3b