Universal Security Instruments HS-5300 - Manual (Page 2)

IMPORTANT SAFETY TIPS
1. Do not install the alarm where it will be exposed to direct sunlight or rain.
2. The alarm siren is very loud. Never put the product close to your ear.
3. The sensor should be directed away from heat sources such as radiators, heating
ducts and stoves.
4. If the product goes off at random, it may be located too close to a heat source.
Changing the location or direction of the sensor alarm can remedy this.
5. The sensor alarm can provide valuable protection for your home and property if
utilized properly. However, this unit cannot guarantee complete protection against
burglary or robbery. Therefore, the manufacturer will not be held responsible for any
loss or damages which could occur.
PROGRAMMING
NOTE: When you first install the battery, the initial security code set by the factory is
"0-0-0." You can program your own security code (up to 6 digits). If more than
6 digits are entered, you will hear an error tone.
1. To change an existing code to a new code:
a. Enter the old code number (0-0-0 is factory preset).
b. Press the "PROG" button.
c. Enter your new security code (1 to 6 digits).
d. Press the "PROG" button again.
AC Adaptor (FIG. 4)
Use only a 9 Volt DC 200 mA AC Adaptor (not included)
with a 3.5mm diameter male plug, center positive (+).
Shelf Top Mounting (FIG. 3)
Turn the sensor head clockwise 180 degrees to the back,
then turn the head upwards to the desired angle. Place it
on the shelf top location you selected.
Wall Mounting (FIG. 2)
Using the battery cover as a template, mark the locations
of the holes and install anchors and screws. Place the
sensor alarm over the screws and slide the product down
to secure in place.
The sensor alarm should be mounted between 3 and 6.5
feet (1 to 2 meters) above the floor for best coverage of
the protection area. Adjust the sensor head left or right
for the best direction of detection area.
INSTALLATION
Battery (FIG. 1)
1. Remove the screw from the battery compartment cover
and slide it down to remove.
2. Install a 9 Volt Alkaline battery (not included).
3. Replace the battery compartment cover and screw.
FIG. 1
FIG. 2
FIG. 3
FIG. 4