United States Stove Company B2045N - Manual (Page 14)

14 14 14 14 14
Annual inspection and cleaning by your dealer or qualified service technician is recommended to prevent malfunction
and/or sooting.
Remove front screen, (see page 11). Carefully lift screen from locating stubs and set aside during cleaning. Refer to
instructions on page 11 for installation of screen. Do not operate the unit with the screen removed.
Do not operate the unit with the screen removed. Do not operate the unit with the screen removed. Do not operate the unit with the screen removed. Do not operate the unit with the screen removed.
Remove logs, handling carefully by holding gently at each end. Gloves are recommended to prevent skin irritation from
ceramic. If the skin becomes irritated, wash gently with soap and water. Refer to manual for correct log placement.
Periodic Cleaning Periodic Cleaning Periodic Cleaning Periodic Cleaning Periodic Cleaning
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
Wait 30 seconds before readjusting the heater when the control has been turned Wait 30 seconds before readjusting the heater when the control has been turned Wait 30 seconds before readjusting the heater when the control has been turned Wait 30 seconds before readjusting the heater when the control has been turned Wait 30 seconds before readjusting the heater when the control has been turned
down to a lower setting.
down to a lower setting. down to a lower setting. down to a lower setting. down to a lower setting.
WARNINGWARNINGWARNINGWARNINGWARNING
PILOT FLAME PILOT FLAME PILOT FLAME PILOT FLAME PILOT FLAME
The pilot flame should always be present when the
heater is in operation and should just touch the top of the
thermocouple tip (FIGURE 9).
If the pilot flame does not touch the thermocouple, then
the main burner is unlikely to function reliably (FIG-
URE 10).
WARNING WARNING WARNING WARNING WARNING
Turn off heater and allow to cool before cleaning. Turn off heater and allow to cool before cleaning. Turn off heater and allow to cool before cleaning. Turn off heater and allow to cool before cleaning. Turn off heater and allow to cool before cleaning.
CLEANING / SERVICING CLEANING / SERVICING CLEANING / SERVICING CLEANING / SERVICING CLEANING / SERVICING
FIGURE 9. Pilot Flame FIGURE 9. Pilot Flame FIGURE 9. Pilot Flame FIGURE 9. Pilot Flame FIGURE 9. Pilot Flame FIGURE 10. Incorrect Shape of Pilot Flame FIGURE 10. Incorrect Shape of Pilot Flame FIGURE 10. Incorrect Shape of Pilot Flame FIGURE 10. Incorrect Shape of Pilot Flame FIGURE 10. Incorrect Shape of Pilot Flame
MATCH LIGHTING INSTRUCTIONS MATCH LIGHTING INSTRUCTIONS MATCH LIGHTING INSTRUCTIONS MATCH LIGHTING INSTRUCTIONS MATCH LIGHTING INSTRUCTIONS
If the pilot will not light using the piezo ignitor, you can light the pilot with a match. First, locate the pilot. The pilot
is located between the burner tube on the right end (facing the unit), inside the firebox. To light pilot with a match,
move the gas control (knob B, pg. 13) to the pilot position and hold down. Light match and place near pilot. Once
pilot is lit, continue to hold the knob for about ten seconds. Then follow steps 9 thru 13 on page 13.
CHECKING FLAME APPEARANCE CHECKING FLAME APPEARANCE CHECKING FLAME APPEARANCE CHECKING FLAME APPEARANCE CHECKING FLAME APPEARANCE
Flames from the pilot and burner should be visually checked when the heater is installed. In addition, a periodic check
of the flames should be made.