U-Line Wine Captain Cooler - Manual (Page 12)

7
Electrical Requirement
Provide a 115 volt, 60 cycle, AC only (normal household) three prong
grounded electrical outlet. DO NOT use an extension cord. DO NOT use
an adapter to bypass the ground. DO NOT alter or deform the electrical
plug in any manner.
Reversing The Door
Depending upon the location of the unit, it may be desirable to
change the side on which the door is mounted.
To reverse the door mounting on the 15WC Wine Captain, perform
the following:
1. Remove top hinge from cabinet (3 screws).
2. Lift door off bottom hinge.
3. Remove bottom hinge from cabinet (2 screws) and install on opposite
side of cabinet.
4. Remove top hinge plate (2 screws) from door and install on bottom,
opposite side of door.
5. Remove bottom hinge plate (2 screws) from door and install on top
opposite side of door.
6. Replace plastic spacer on bottom hinge and set door in place.
7. Replace plastic spacer on top hinge and install top hinge on cabinet.
8. Adjust as required to assure proper door seal.
To reverse the door mounting on the 75WC Wine Captain, perform
the following:
1.
Remove the bottom hinge (2 screws) from door.
2. Remove top hinge (2 screws) from door.
3. Remove door.
4. Remove top hinge (3 screws) from cabinet. Invert and install on
bottom, opposite side of cabinet.
5. Remove bottom hinge (3 screws) from cabinet. Invert and install on
top, opposite side of cabinet.
6. Attach top hinge to door.
7. Attach bottom hinge to door.
8. Adjust as required to assure proper door seal.
Door Adjustment
The Wine Captain door should always be squared to the cabinet to
ensure a proper seal. To properly adjust the door, please follow this
procedure:
1.
Loosen (do not remove) the three screws in the door hinge
plate on the top of the cabinet.
2. Align the door so that it is squared to the cabinet.
3. Tighten the three screws on the top hinge plate.