Vax X3 - Manual (Page 8)

7
H
O
W
T
O
O
P
E
R
A
T
E
STARTING UP
BRUSHROLL RESET
BRUSH VACUUMING
Holding the power cord by the plug, pull the
cord out completely. Red tag will indicate the
end of the cord. Plug into the outlet.
1.
Tilt the upright vacuum cleaner
back before you start vacuuming.
At the same time, use your foot
to press the nozzle down onto
the carpet.
1.
If something becomes lodged and
brushroll shuts off, turn cleaner off
and remove obstruction. Once the
problem has been fixed, the vacuum
cleaner can be switched back on
again after approximately 2 minutes
by pressing the reset button.
1.
Switch the upright vacuum
cleaner on or off by pressing the
on/off switch.
3.
For easier handling while
vacuuming, hook the power
cord onto the power cord
hook.
2.
Brush Vacuuming on carpeted floors:
• The brushroll is switched on or off
using the brushroll on/off switch
(Diagram 2). Switch brushroll on for
carpeted floors.
• The rotating brushroll loosens deeply
embedded dirt and brings it to the
surface.
Vacuuming on smooth surfaces:
• Switch brushroll off to obtain the
best results when vacuuming smooth
barefloor surfaces.
2.
NOTE
: The brushroll is automatically switched off when it is in the vertical upright position.
RESET BUTTON