VBrick Systems VB Directory System - Manual (Page 5)

V B D I R E C T O R Y U S E R S G U I D E V E R S I O N 4 . 1
C O P Y R I G H T V B R I C K S Y S T E M S P A G E 5 J U N E 2 0 0 7
2: Installation
Your Network
The PC running VBDirectory needs to be connected to the network, and there needs to be at
least one VBrick configured to send Management SAPs (please refer to the VBrick Admin
Guide). It operates on any PC that has access to the network.
System Requirements
VBrick Systems recommends the following minimum system specifications:
• • 2000, XP, or Vista.
• • Any Pentium processor.
• • 128 Mb RAM.
• • Minimal space required (under 400k).
Installation
VBDirectory is installed in either of the following two ways:
• • Run SetupVBDirectory4_1_0.exe and follow the on-screen directions. The Setup
program installs the program on your computer. It is recommended that the default
settings be used. The setup installs the software in the default location in Program
Files>VBrick>VBDirectory . Use the default folder or specify the location.
• • VBDirectory is installed along with the installation or upgrade of VB1000-2000-3000
MPEG-1 and VB400-5000-6000 MPEG-2 and MPEG-4 VBrick appliances when
using Intelligent Download, the VBrick installation and upgrade program.
CHAPTER two
IMPORTANT: VBDirectory must be closed during installation or upgrade to avoid an
error being reported. If the application is open, just close the file and complete the
installation.