VTech CS6229-2 - Manual

Quick start guide
Battery installation and charging
Install the battery as shown below. After
installing the battery, you might be able to make
and receive short calls. For best performance,
charge the handset battery for at least 16 hours
before use.
Make, answer and end a call
Make a call
Press /FLASH or .
You hear a dial tone.
Dial the number.
Make a predial call
Dial the number.
Press
/FLASH or .
Answer a call
Press /FLASH , or any of the dialing keys
( 0 - 9 , #, * ).
End a call
Press OFF/CLEAR or put the handset in the
telephone base or charger.
1.
2.
1.
2.
for models CS6228-3/CS6228-6/CS6229/
CS6229-2/CS6229-3/CS6229-4/CS6229-5
Install the telephone base and
charger(s)
Install the telephone base and charger(s) as
shown below.
Use only the power adapter(s) and
battery(ies) supplied with your VTech
telephone.
For complete feature instructions, please
refer to your user’s manual.
1.
2.
Telephone base
Telephone
line cord
Telephone
base power
adapter
Telephone
wall jack
If you have DSL
high speed Internet
service, a DSL
filter (not included)
is required.
Electrical outlet
not controlled by
a wall switch
Charger adapter
Charger
1 2
CHARGE light
3 4
Plug the battery securely
into the plug inside
the handset battery
compartment, matching
the color-coded label.
Place the battery with
the label THIS SIDE
UP facing up and the
wires inside the battery
compartment.
Align the cover flat
against the battery
compartment, then slide
it towards the center of
the handset until it clicks
into place.
Charge the handset by
placing it in the telephone
base or charger. The
CHARGE light is on when
the handset charges.
If the battery
compartment cover is on
the handset, press the
indentation and slide the
cover to remove.
5
Turn the answering system
on or off
The answering system must be turned on to
answer and record messages.
When the answering system is turned on, the
ANS ON/OFF light on the telephone base will be
on and ANS ON will display on the handset.
To turn on or off with
the telephone base:
Press ANS ON/OFF
to turn the answering
system on or off. If the
answering system is
turned on, it announces,
“Calls will be answered.”
If the answering system is
turned off, it announces,
“Calls will not be answered.”
To turn on or off with a handset:
Press MENU/SELECT to show the menu
when the handset is not in use.
Press
MENU/SELECT to select
>ANS. SYSTEM.
Press or to select >
ANS SYS SETUP,
then press MENU/SELECT.
Press MENU/SELECT to select
>ANSWER ON/OFF.
Press or to choose
ON or OFF, then
press MENU/SELECT.
•
1.
2.
3.
4.
5.