Veo Infra-Red - Manual (Page 13)

Network Camera User’s Guide
13/83
environment, you can find out its IP address and other IP parameters as follows:
1. Edit the Name of this Network Camera. Note that use “_” or “-“ to replace
“space” character to separate the name string. For example, “Dome_IP”
or “Dome-IP” will be right. However “Dome IP” will not work here.
2. Might be needed to update the IP address of this Network Camera.
( Power recycling i might be necessary)
3. Might be needed to update the Gateway Address. ( Power recycling might
be necessary)
4. Might be needed to update the Network Mask (255.255.255.0). ( Power
recycling might be necessary)
5. Might be needed to modify the port number 1 of HTTP access. ( Power
recycling might be necessary)
6. Might be needed to modify the port number 2 of HTTP access. ( Power
recycling might be necessary)
7. ‘Submit’ it.
Click “submit”, the IP information of this Network Camera will be updated after
seconds
Install the Network Camera with an ADSL Router
If the Network Camera was installed on the LAN with an ADSL router, then the Network
Camera can get a dynamic IP address from the DHCP server. However, if the Network
Camera wants to be access from the WAN, its IP address needs to be setup as fixed IP,
also the Virtual Server function of ADSL router needs to be setup as follows:
1. Setup the Network Camera as Fixed IP, such as 192.168.0.49.
2. Enter the administrator page of ADSL router. (Use zonet ASDL router as an
example).
3. Enter the Virtual Server Page.
a. Setup the mapping of HTTP Port (80) to 192.168.0.49.
b. Restart the ADSL router.
Then the Network Camera can be access from WAN by the ADSL WAN IP Address.