Vestax PMC 250 - Manual (Page 6)

u HI CUT (Fader type cut switch HI)
When this volume is set to bottom position, high
frequency range is cut of completely regardless
of the position of the HI level control. The HI
level control knob becomes active when this
volume is set to maximum top position.
i MID CUT (Fader type cut switch MID)
When this volume is set to bottom position, mid
frequency range is cut of completely regardless
of the position of the MID level control. The MID
level control knob becomes active when this
volume is set to maximum top position.
o LOW CUT (Fader type cut switch LOW)
When this volume is set to bottom position, low
frequency range is cut of completely regardless
of the position of the LOW level control. The
LOW level control knob becomes active when
this volume is set to maximum top position.
!0 INPUT FADER
Used to adjust the input level of each program.
Please replace with IF-250 when it is worn out,
or with the optional rotary fader unit.
5
MASTER SECTION
!1 POWER INDICATOR
The LED light when the power is on.
!2 LED LEVEL METER
The bar graph level meters indicate the master
output level L channel and R channel or input
level of each program program 1 and 2 .
!3 METER SELECT
When this switch is set to MASTER, the bar-
graph meter indicates the master output level L
channel and R channel . When it is set to
PGM, the left meter shows the input level of
PGM1 and the right meter shows the input level
of PGM2.
!4 AUX (AUX level volume)
Used to adjust the Input level of AUX IN.
2 1
MAX MIN
MAX MIN
MAX MIN
PRO FESSIONAL MIXING CONTROLLER
PGM 2 LEVEL
AUX
MASTER BOOTH OUT
METER SELECT
MASTER
+6 +3 +2 +1 0 -1 -2 -4 -7 -10 -20 -30 -30 POWER -20 -10 -7 -4 -2 -1 0 +1 +2 +3 +6
PGM
PGM 2 Rch PGM 1 Lch
16
17
13 14
15
12
11
!5 MASTER (MASTER level volume)
Adjusts the output level of LINE OUT and PA
OUT.
!6 BOOTH OUT
Adjusts the output level of BOOTH OUT.
!7 CROSS FADER
The signal from PGM1 is output when the cross
fader is set to the left side. The signal from
PGM2 is heard when the cross fader is set to
the right side. When the cross fader is set at
centre position, both programs will be mixed
and output at the same time. Please replace it
with the CF-PCV when it is worn out.
MAX MIN MAX MIN
LEVEL INPUT FILTER
MIC
18 19 20
MICROPHONE SECTION
!8 MIC INPUT (Mic Input Jack)
Input jack for the microphone.
!9 MIC LEVEL (Mic Level Volume)
Adjusts the input level of the microphone.
@0 MIC FILTER (Mic Filter Volume)
Adjusts the cut off frequency of the microphone
input. It is used to prevent low frequency noise
such as breathing, vibration, etc.