Appendix, A. troubleshooting, Status led – Vivotek PT7135 User Manual
Page 52: Reset and restore
- 51 -
www.vivotek.com
Appendix
A. Troubleshooting
Status LED
The following table lists the LED patterns in general.
Condition
LED color
Loading system after power on
Steady red, blue, green
During booting procedure
Steady red, blue, green
Detecting and setting network
Steady green and blue. Blink red till physical
network and IP address are confirmed.
After network is setup (system up)
Blink green every second and steady red
During the upgrade firmware process
Blink green every second and fast blink red
Enable audio
Steady blue. Disable audio will turn off blue
LED.
Reset and restore
There is a button in the back side of the Network
Camera. It is used to reset the system or restore the
factory default settings.
RESET: Click on the button.
RESTORE:
1. Press on the button continuously.
2. Wait for all LED blink fast.
3. Free the button.
- User's Manual
VIVOTEK - A Leading Provider of Multimedia Communication Solutions