Vestax PMC37Pro - Manual (Page 7)

7
CROSS FADER SECTION
MASTER-MONITOR SECTION
C.F. MODE
CROSS FADER
B A
14
13
MONITOR
MONITOR
SELECT
MONITOR LEVEL
PHONES
MASTER
R L
MAX MIN
MAX MIN
MAX MIN
AUX 2 AUX 1
MASTER
CUE
SPLIT STEREO
BAL
MASTER LEVEL
SUB MASTER LEVEL
15
16
17
18
19
20
21
22
23
24
24
LEVEL
PHONES
+8
+5
+3
+1
+0
-1
-3
-5
-7
-10
-15
CUE L R
POWER
!3 CROSS FADER
Mixes the signal assigned by C.F. ASSIGN SWITCH
(
!0) to A side of the crossfader and B side. When
the crossfader is set in the center position, both A
and B can be heard. This is a detachable fader for
ease of replacement with CF-37PCV when it is worn
out. See "HOW TO CHANGE THE FADER UNIT".
!4 C.F. CURVE CONTROL
Adjusts the crossfader curve. Counter-clockwise
rotation gives a gentle crossfade, good for long
running mixes. Clockwise rotation gives a steep
crossfade, suitable for scratching and cutting.
!5 CUE LEVEL METER
The LED bar level meters indicate the signal level of
PGM input selected by CUE SWITCH (
!1).
!6 MASTER OUT LEVEL METER
The LED bar level meters indicate the L and R
outputs.
!7 POWER INDICATOR
Lights up when the POWER SWITCH ( #1) is on.
!8 MASTER BALANCE VOLUME
Adjusts the signal balance of the L to R side of
outputs from MASTER OUTPUT JACK (
#9) on the
rear panel.
!9 MASTER LEVEL VOLUME
Adjusts the signal level outputs from MASTER
OUTPUT JACK (
#9) on the rear panel.
@0 SUB-MASTER LEVEL VOLUME
Adjusts the signal level outputs from SUB-MASTER
OUTPUT JACK (
$0) on the rear panel.
@1 MONITOR SELECT SWITCH
Used to select the cue monitor for PGM1 4
(selected by CUE position), MASTER out and effect
receive (AUX 1 or AUX 2).
@2 MONITOR STYLE SELECT SWITCH
When this switch is set to "SPLIT", the master signal is
always heard through the right ear-cup of the
headphones. The signal selected by MONITOR
SELECT SWITCH (
@1) will be heard in the left ear-cup.
This enables both programs to be monitored
simultaneously, thus assisting in beat mixing. When
this switch is set to "STEREO", no master output is
heard in the headphones, and only the signal
selected by MONITOR SELECT SWITCH (
@1) will
be heard in both ear-cups.
@3 MONITOR LEVEL VOLUME
Adjusts the monitor level through the headphones.
@4 HEADPHONE JACK
Use this jack to connect the headphones.
Headphones from 8ohm to 600ohm can be used.
1 2 3
1 2 3
L
L
E
E
V
POSITION POSITION POSITION
fig-A CROSS FADER CURVE
Rotate clockwise this volume,
C.F curve changes like a chart (
)