Visioneer MFC7050C - Manual (Page 57)

I N I T I A L S E T U P
5-5
Initial Setup
Setting the Beeper Volume
You can set the beeper to LOW, HIGH or OFF. The default setting
is LOW. When the beeper is set to LOW or HIGH, the MFC beeps
every time you press a key or make an error, and at the end of fax
sending or receiving.
1 Press Function , 1 , 1 , 4 .
2 Press or to select your setting.
3 When the screen displays the setting you want, press Set .
4 Press Stop to exit.
Choosing the Handset Volume
Before you begin to use the machine, you must decide if you need
to set the handset volume to AMPLIFY:ON for a user who is
hearing-impaired.
VOLUME AMPLIFY: OFF
This default setting is appropriate if none of the users are hearing-
impaired. During a conversation, users can press
L or H on the
control panel to adjust the volume. When the handset is replaced,
the handset volume will remain until you change it again.
VOLUME AMPLIFY: ON—TEMPORARY
This setting is appropriate if some of the users are hearing-
impaired. During a conversation, users can press
L or H on
the control panel to adjust the volume to LOW, HIGH or
AMPLIFY. When the handset is replaced, the handset volume
returns to the default setting of LOW.
VOL AMPLIFY:ON—PERMANENT
Choose VOL AMPLIFY:ON—PERMANENT if all of the users are
hearing-impaired. During a conversation, users can press
L or
H on the control panel to adjust the volume to LOW, HIGH or
AMPLIFY. When the handset is replaced, the handset volume
returns to the default setting of AMPLIFY.
When you press L or H on the control panel to adjust the
volume, the display shows the setting you are choosing. Each key
press changes the volume to the next setting.
Caution
It is important that you do not choose PERMANENT unless all
the users are hearing-impaired. Otherwise, the default setting of
AMPLIFY may damage the hearing of some users.