Vantec UGT-IS100R User Manual
Page 17
UGT-IS100R
Page 17
F
1. Setup the RAID Array prior to driver installation and boot up
to Windows.
2. Please insert the CD driver bound with 4+1 SATA II 300
IDE/PATA PCI-E Combo Host Card w/ RAID & Port Multiplier
into your CD-ROM Drive.
3.
At the Windows desktop, click
Start, then Run.
4. Type
D:\
UGT-IS100R\2000_XP_2003_Vista\setup.exe
, click
OK. (Change D:\ to match your CD-ROM drive letter)
5. Follow the on-screen instructions to complete the
installation.
6.
Restart Windows to complete the installation.
For Windows® Vista-x64
or A New Installation
A new installation requires a floppy disk for the driver
installation. To make this floppy disk, copy the contents of
the “
UGT-IS100R\XP_2003_Vista\Floppy64
” folder, found
on the driver CD, onto a blank floppy disk then follow the
directions below.
1. Setup the RAID Array prior to Windows installation.
2. Follow Microsoft’s Windows installation procedure.