Vanguard Heating VSGF28NTC - Manual (Page 13)

13 107157
OWNER’S MANUAL
For more information, visit www.desatech.com
WARNING: You must operate
this fireplace with the fireplace
screen in place. Make sure fire-
place screen is in place before
running fireplace.
Figure 26 - Installing Fireplace Screen
Notches
Screws for
Mounting
Screen
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install these
logs exactly as instructed. Do not modify
logs. Only use logs supplied with heater.
1. Place front log (#1) on top of the grate.
Make sure the notches in the bottom of
the log fit over the grate prongs (see
Figure 22). Push back of log flush with
metal grate bar.
2. Rest middle log (#2) behind metal posts
on front burner. Make sure the grooves
in the bottom of the log fit over the
grate. Bring the log forward next to the
metal posts (see Figure 23).
3. Slide the grooves in the back of the rear
log (#3) against the rear grate prongs.
Make sure the peg on the log is on top
(see Figure 24).
4. Place the crossover log (#4) on the rear
log and the middle log. Make sure the
peg on the rear log is in the hole in the
bottom of the crossover log. The cross-
over log should fit in the cutout of the
middle log (see Figure 25).
5. Install fireplace screen by slipping
notches of fireplace screen over screws
on front of fireplace (see Figure 26).
INSTALLING LOGS
Figure 22 - Installing Front Log (#1)
Figure 24 - Installing Rear Log (#3)
Figure 23 - Installing Middle Log (#2)
Figure 25 - Installing Crossover Log (#5)
INSTALLATION
Continued
Middle Log (#2)
Rear Log
(#3)
Crossover
Log (#4)
Hole
Peg
Cutout
Peg
Grate Prong
Rear
Burner
Groove
in Back
of Log
Groove
in Back
of Log
Grate
Prongs
Metal Grate Bar
Front Log (#1)
Notch
Metal Post
Metal
Post
Groove
Groove
Grate
CAUTION: Do not remove the
metal data plates attached to the
heater base assembly. The data
plates contain important warranty
information.
Grate
Prong