Vizio VW32L User Manual
Page 29
VIZIO VW32L HDTV20A User Manual
Version 5/20/2008
www.VIZIO.com
29
d. The screen will now change to
show the progress of the search
for Analog (NTSC) and Digital
(ATSC) channels.
Note: DTV digital broadcast is not available in all areas. Refer to
about availability in your area, type of antenna and in which direction to point your antenna. The channel
availability through cable depends upon which channels your cable operator supplies in Clear QAM;
consult your cable operator for more information.
e. When finished, the Complete
screen will be displayed to inform
you that the HDTV has completed
the Initial Setup.
Press the
button on the
remote control to exit and begin
watching TV.
5. Select
Input
Source
Select the Input Source for the HDTV by pressing the INPUT
button on the side of the High Definition TV or using the Input button
on the remote control. Pressing this button will cycle you through the
following options: TV, AV (S-VIDEO), Component1, Component2,
RGB, HDMI1 and HDMI2.
Now follow the procedure below to display channels from a
different signal (External TV Tuner, VCR, Cable Box or Satellite
Receiver) source, using different inputs at the back of you TV set.
a. Select the correct input connection; RF (DTV/TV) connector, Composite (Yellow, Red
and White) connectors, Component (Red, Green, Blue plus Red and White) connectors, HDMI
connectors or Separate-Video (S-Video) plus Red and White connectors (if applicable). Make the
physical connection or hook up.