Vanguard Heating VMH10TN - Manual (Page 21)

21
103670
TO TURN OFF GAS TO APPLIANCE
Shutting Off Fireplace
1. Turn control knob clockwise
Clockwise
to the OFF position.
2. Turn off all electric power to the appliance if service is to be performed.
Shutting Off Burner Only (pilot stays lit)
1. Turn control knob clockwise
Clockwise
to the PILOT position.
THERMOSTAT CONTROL OPERATION
The thermostat used on this fireplace senses the room temperature. At times
the room may exceed the set temperature. If so, the burner will shut off. The
burner will cycle back on when room temperature drops below the set tem-
perature.
The control knob can be set to any heat level between HI and LO.
Note: The thermostat sensing bulb measures the temperature of air near the
fireplace cabinet. This may not always agree with room temperature (depend-
ing on housing construction, installation location, room size, open air tempera-
tures, etc.). Frequent use of your fireplace will let you determine your own
comfort levels.
OPERATING
FIREPLACE
Continued
MANUAL LIGHTING PROCEDURE
1. Follow steps 1 through 5 under Lighting Instructions, pages 19 and 20.
2. With control knob pressed in, strike match. Hold match to pilot until pilot
lights.
3. Keep control knob pressed in for 30 seconds after lighting pilot. After 30
seconds, release control knob.