VIPowER Hi-Speed External Drive USB 2.0 - Manual (Page 24)

Step3 After restart the system, a removable HDD is added to [My Computer].
Choice the removable HDD and click right bottom of mouse. Select the
[format] to format your USB 2.0 Hard Disk Drive.
You only can set the USB 2.0 Hard Disk Drive to one partition in this method.
Method 2
Step1 Go into the MS-DOS mode by click on [Start], choice the [MS-DOS
Prompt] in [Programs]
Step2 At the DOS prompt, type [FDISK] and press Enter.
Step3 If FDISK quit without any message, back to the Windows 98 screen, plug
out the USB 2.0 Hard Disk, re-boot computer, plug in USB 2.0 HDD again
and go back to step 1 to proceed.
Step4 In the first screen of FDISK, answer the question:
Do you want to enable large disk support?
[Y] if you want to build a partition larger than 2GB.
[N] if you want to build a partition small than 2GB.
22 USB 2.0 External Drive