Vestax CDX-15 - Manual (Page 14)

[1] Turn the power on by pressing the POWER switch.
[2] Open the CD door and place the disc into the centre shaft until the ball chucking holds the
CD with a click. Close the CD door.
CD disc starts spinning and the laser pick-up reads the table of contents. Then pauses at the
beginning of the first track.
[3] Press PLAY/PAUSE button.
Starts playback from the first track immediately. Remaining time of the playing track will be shown
on the digital display in minutes, seconds and frames.
[4] Press NEXT button to skip to the next track.
Stop playing current track and starts playing back from the beginning of next track.
[5] Press PLAY/PAUSE button to stop playback. Press PLAY/PAUSE button again to re-start
playback.
[6] Press STOP button when the CD is not played for a while. This prevents the laser pick up
from wearing out. The CDX-15 starts playing back from the beginning of the track when
PLAY BUTTON is pressed once again.
STANDBY MODE
In case the player is kept in PAUSE mode for over ten minutes, the CDX-15 stops spinning automatically and is set
to STANDBY MODE in order to protect the CD mechanism from wearing out. STANDBY MODE is cancelled if
any of the following is done.
[7] Open the top door and pull out the disc.
[1] Start to play back by pressing PLAY/PAUSE button.
[2] Set MONITOR mode by pressing MONITOR button.
[3] Search for the approximate position to start by moving the STICK CONTROLLER left or right.
[4] Set PAUSE mode by pressing PLAY/PAUSE BUTTON and press MONITOR button.
Repeat sound of pause point can be monitored in 4 frame cycles.
[5] Now the STICK CONTROLLER is set to the SEARCH mode.The exact start position can be
searched by moving the STICK CONTROLLER.
[6] Press MONITOR button after the start position is accurately set.
Repeat sounds stops.
[7] Play back by pressing PLAY/PAUSE button again.
[8] Adjust the pitch by using PITCH CONTROL FADER and STICK CONTROLLER to match
the tempo with the other music.
OPERATION (Same for Player A and B)