Victor Enterprise 1260-3 - Manual (Page 8)

- 8 -
2.
↓ 5/4 ↑ Decimal Rounding Selector
↓
This causes automatic round down (truncation).
5/4 This setting causes automatic round off. If the last digit of the result
that will be printed or printed/displayed upon rounding is followed by a
value of 0 to 4, the digit is unchanged. If the last digit of the result that
will be printed or printed/displayed upon rounding is followed by a
value of 5 to 9, the digit is rounded up.
↑
This setting causes automatic round up
3.
• ∑
Sigma Switch
∑
When the Sigma switch is in the “
∑” position, the results of
multiplication or division calculations completed by the = or % key are
automatically added to the accumulator.
•
When the Sigma switch is in this position, the results of these
calculations are not added to the accumulator. The sum of these
accumulations is displayed by depressing the Subtotal key and are
displayed and cleared by depressing the Total key.
4.
• GT Grand Total Switch
•
Calculation without Grand Total
GT Any total taken with T key is automatically accumulated to memory.
The accumulated grand total can be recalled by pressing the MT key.
5. OFF/ON/PRINT Power/Printer Select Switch
OFF Turn Off the calculator.
ON Printer is activated only when feed key or #/S key is pressed.
PRINT Printer is activated as long as calculator is turned on.