VIEWSONIC PJD6212 - Manual (Page 18)

EN-15
Powering On/Off the Projector
Powering On the Projector:
1. Remove the projector lens cap.
2. Complete the AC power cord and peripheral signal cable(s) connections.
3. Press button on the control panel or the POWER button on the remote
control to turn on the projector.
The projector takes a minute or so to warm up.
4. Turn on your source (computer, notebook, DVD, etc.). The projector automatically
detects your source.
„ If you are connecting multiple sources to the projector simultaneously, press
the SOURCE button on the control panel or the Source button on the remote
control.
Warning
„ Remove the lens cap first before powering on.
„ Never look into the lens when the lamp is on. This can damage your eyes.
„ This focal point concentrates high temperature. Do not place any object near
it to avoid possible fire hazard.
Powering Off the Projector:
1. Press button on the control panel or the POWER button on the remote
control to turn off the projector lamp. You will see a message "Power off? Press
Power again" appear on the screen.
2. Press button on the control panel or the POWER button on the remote
control again to confirm.
„ The cooling fans continue to operate for cooling cycle.
„ When the Lamp LED begins flashing, the projector has entered stand-by mode.
„ If you want to turn the projector back on, you must wait until the projector has
completed the cooling cycle and has entered stand-by mode. Once in stand-
by mode, simply press
button on the control panel or the POWER button
on the remote control to restart the projector.
3. Disconnect the AC power cord from the electrical outlet and the projector.
4. Do not turn on the projector right after power off.