Venturer PLV76198E - Manual (Page 5)

GB - 5
QUICK INSTALLATION
When you turn on your television set for the first time, be sure to place it on a solid stable surface. To avoid danger, do
not expose the TV to water, or a heat source (e.g. lamp, candle, radiator). Do not obstruct the ventilation grid at the rear
and be sure to leave sufficient gaps around the unit as shown.
1. Connect an antenna or Cable TV COAX cable to the TV's
antenna input jack.
2. Connect the power cord.
3. Press the / ON button to turn on the unit.
4. Use the / button to highlight OSD Language, then press
the ENTER or button to select the menu language from
English / Español / Français.
5. Press the / button to highlight Antenna, then use the
ENTER or button to select “Air”, “Cable STD”, “Cable HRC”,
“Cable IRC” or “Cable Auto“.
6. Use the / button to highlight Auto Scan, then press the
ENTER or button to confirm.
7. The unit will immediately search all channels for those with
adequate signal strength and store those channels with signals
in memory. The unit will take a few minutes to finish auto scan
and after this is completed, the unit will switch to the first
channel found.
TURNING ON ThE UNIT FOR ThE FIRST TIME
The first time you turn on the unit, the unit will enter the setup mode. You can easily follow the prompt message on the
screen to complete basic TV settings.
Make sure the TV antenna or CATV cable has been connected properly to the TV antenna input jack on the rear of
the system.
If you subscribe to Cable TV Service, we recommend you pick
"Cable Auto", however you might find you get improved results
using "Cable STD", "Cable IRC", or "Cable HRC" - these are
different standards used by various Cable Systems.
2 3/8”
2 3/8” 7 7/8”
PLV76198S23E10 IB ENG.indd 5 9/8/2009 9:57:24 AM