Viper Model 480XV - Manual (Page 25)

26 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s , i n c .
transmitter sensor disable
To temporarily disable a sensor input, arm the system. Press the
button again and the system will respond with 3 indicator
flashes. This means all sensor warn-away triggers are bypassed.
Press the button again and the system will respond with 4
indicator light flashes. This means all sensor warn-away and full
triggers are bypassed.
autoimmobilisation
The built-in Triple Circuit Immobiliser will automatically arm
(indicated by a slow LED flash), 30 seconds after the ignition is
turned off. (This feature is a Thatcham and EC requirement and,
therefore, is not user-programmable.) To disarm the Immobiliser
when it has AutoImmobilised, either use the remote control to
arm and then disarm the system, or turn the ignition on and
press the or button or enter your 4-digit PIN code.
disarming
To disarm the system, press . You will hear two chirps, and
the indicators will flash twice. If the vehicle's central locking is
connected to the system, the doors will unlock. If the siren chirps
either four or five times when disarming, refer to the Diagnostics
section of this guide. This is called Tamper Alert and means the
system has triggered while you were away.
➜
➜
➜