Add and register a handset, Getting started – VTech LS6226-2 User Manual

Page 6

Advertising
background image

3

Getting started

Add and register a handset

Each newly purchased handset (

LS6205) must be registered to the

telephone base (

LS6215 or LS6225) before use. When first purchased,

each expansion handset shows

NOT REGISTERED.

When first purchased, each expansion handset shows

NOT REGISTERED.

You may need to charge the handset before registering to the telephone

base. For more details on battery charging, see the table on page 2.
To register a handset:

Place the unregistered handset in the telephone base or charger. If

PRESS FIND HS 4 SEC ON BASE does not appear on the handset

screen after a few seconds, remove the handset and place it in the

telephone base or charger again.
On the telephone base, press and hold

FIND HANDSET for about four seconds (until the red IN USE light on the

telephone base turns on) and then release the

button. The handset shows

PLEASE WAIT...

and it takes up to 60 seconds to complete the

registration. The handset shows

HANDSET

X REGISTERED (X represents the handset

number assigned) and you hear a beep when

the registration completes.

When the registration is complete, the newly

registered handset is assigned the next available

handset registration number. For instance, if you

already have

HANDSET 1 and HANDSET 2, the next registered handset is

HANDSET 3.

1.

2.

If the registration fails, the handset shows

NOT REGISTERED. To reset the

handset, remove the handset from the telephone base or charger and place

it back in. Try the registration process again.

You cannot register a handset if any other system handset is in use.
Only one handset can be registered at a time.


Advertising
This manual is related to the following products: