Vinotemp VT-16TEDS - Manual (Page 10)

10
W W W . V I N O T E M P . C O M
PROBLEMS WITH YOUR WINE CELLAR
You can easily solve many common wine cellar problems, saving you
the cost of a possible service call. Try the suggestions below to see if
you can solve the problem before contacting Vinotemp at
[email protected].
TROUBLESHOOTING GUIDE
PROBLEM POSSIBLE CAUSE
Wine cellar does
not operate
• Not plugged in.
• Using wrong voltage.
• The circuit breaker tripped or there is a blown
fuse.
Wine cellar is not
cold enough • Check the temperature control setting;
external environment may require a higher
setting.
• The door is opened too often.
• The door is not closed completely.
• The door seal does not seal properly.
• The wine cellar does not have the correct
clearances to operate efficiently and safely.
Light does not
work
• Call the service center.
Vibrations • Check to assure that the wine cellar is level.
Wine cellar
seems
to make too
much noise
• The wine cellar is not level.
• Check the fans inside and at the back of the
unit.
Door will not
close
properly
• The wine cellar is not level.
• The doors were not properly installed.
• The seal is weak.
• The shelves are out of position.
Temperature LED
display is blank
• Main control board does not work.
• The Power Control Board is not functioning.
• There is some problem with the plug (no
power supply).
Temperature LED
display error • Display has suffered too much wear and tear.
• Temperature sensor has been cut off.
Buttons are not
functional
• Temperature controller panel is damaged.