Venture Products VP100L - Manual (Page 10)

10
USER’S INSTRUCTIONS
3. DISPLAYS DESCRIPTIONS
Standard display at start-up will show VP100 or VP100L accordingly
After start-up, the display shows the volume (attenuation level) of -
66dB, and the first input RCA1 is activated.
The volume can be adjusted through remote control or the Volume
knob on the right, from –65dB (low volume) to 0dB (loud).
By using the remote control or selection knob, the different inputs can
be selected: RCA1, XLR2, RCA3, XLR4, RCA5, XLR6, RCA7, XLR8.
By a slight push on the Volume knob the setup is activated.
By turning the Selector knob to the right, the left channel balance is
accessed. The balance is limited to 9dB difference between channels.
Use the Volume knob to adjust the balance level.
Turn the Selector knob further to the right to access the right channel
balance setting.
By further turning the Selector knob, the level of the input of each
appliance can be adjusted accordingly up to – 10 dB.
Push lightly on the Selection knob to exit at any step from the set-up
program. Parameters are now stored within the preamplifier.
Last in the set-up program, we can teach the preamplifier some
new remote control codes. This functionality is only to be used
when using a new remote control.
This option is defaulted to OFF (disabled). Turn the volume
knob right to enable it. Turning left sets it back to OFF.