Vinotemp VT-BC-1 - Manual (Page 5)

PARTS AND IDENTIFICATION
A. Cabinet
B. Glass Door
C. Lock
D. Drip Pan
E. Compressor
F. Adjusting Leg
ELECTRIC CONNECTION
z This unit operate with an 115V~60Hz power supply. Check the electrical
outlet for proper voltage.
z Warning: Do not plug other electrical appliances into cooler outlet. The
coolers are supplied with 8ft length electric cord. Do not use extension
cords. Provide an outlet just for the cooler. If the cord is damaged
replace it and do not try to repair it.
z For your own safety and for protection of the cooler, verify the existence
of the ground circuit in the electrical power supply. In case of doubts, ask
the assistance of an authorized electrician.
INSTALLATION
• Remove all the packing material before using your cooler.
• Clean the interior surface with a soft cloth and lukewarm water.
• Locate the cooler in a dry and airy place.
• Coolers transported in the horizontal position, must be returned to the
upright position, and not plugged in for 1 hour. This is essential for
proper operation.
• Cooler transported in the horizontal position requires the drain pan,
located on top of the compressor, be checked for proper location.
• Install your cooler on a solid and level surface (other than carpet). This
will ensure a vibration and noise-free operation.
• Do not locate the appliance close to walls, this could damage the electric
cord and may block the air circulation to the appliance. Keep the cooler a
distance of at least 4 inches from wall.
• Do not block the air intake that ventilates the condenser unit.
5 1 7 6 3 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
i n f o @ v i n o t e m p . c o m