Velodyne Acoustics SC-602 - Manual (Page 5)

2
.
w w w . v e l o d y n e . c o m
SC-602 Amplifier User’s Manual
S C - 6 0 0 I W, S C - 6 0 0 I F / I C S U B W O O F E R S
SC-600 IW (In-Wall):
- Two high excursion 6.5” active drivers, two 12.5” x 3” oval
passive radiators with ribbed rubber surround
- High-excursion rubber surround
- 2” dual layer voice coil
- Frequency Response: 37 - 120 Hz (+/- 3 dB)
- 4 ohm impedance
SC-600 IF/IC (In-Floor/In-Ceiling):
- 12” (9.7” piston diameter) subwoofer
- 2.5” dual layer voice coil
- Oversized spider for linearity at high excursion
- High-excursion rubber surround
- Frequency Response: 25 - 120 Hz (+/- 3 dB)
- 4 ohm impedance
Be sure to do the following to ensure the best performance from your subwoofer:
❑ If possible, optimize the placement of the subwoofer(s) in the listening area.
See page 10 of the User’s Manual.
❑ Install and wire the subwoofer per the instructions on pages 3 - 8.
❑ Set the amp to the proper subwoofer model per the instructions on page 11.
❑ Select the proper volume level. See page 4.
❑ Select the proper low-pass crossover frequency. See pages 9 - 10.
❑ Equalize the subwoofer using the microphone and Auto-EQ feature. See page 12.
❑ Adjust the phase control on the remote to the correct setting. See page 12.
❑ Select the correct preset for the source material. See page 13 - 14.
Your new Velodyne amplifier provides for a number of installation options. Read all the
installation information below in order to determine which installation option is best for your
system. Remember to perform all installation procedures with system power turned off.
Se tup Checklis t