Velodyne Acoustics SMSTM -1 User Manual
Page 12
6
.
w w w . v e l o d y n e . c o m
Digital Drive User’s Manual
Figure 2: Digital Drive Front and Rear Panel Connections
(1)
POWER – Press the POWER switch to the ON position to activate the SMS-1. If the
unit is to be left unused for an extended period of time, press the switch to the OFF
position to prolong the life of the SMS-1.
(2)
IR Remote Sensor.
(3)
LCD Display – This display shows subwoofer volume, preset, and indicates auto-EQ,
self- EQ, mute, and night mode operation.
(4)
MIC INPUT – This XLR input jack is for the XLR microphone cable.
(5)
VOLUME UP/DOWN – Press the black UP pushbutton to incrementally raise your
SMS-1’s system volume; press the black DOWN pushbutton to incrementally
lower your SMS-1’s system volume. Note the use of these buttons during
software updates.
(6)
LFE OUTPUT – This balanced connector sends the conditioned subwoofer audio signal
to your subwoofer.
(7)
LFE INPUT – This XLR input jack receives the LFE signal from your receiver
or processor.
(8)
MIC INPUT – This XLR input jack is for the XLR microphone cable.
(9)
IR REMOTE – This connection allows for hook-up of an IR signal from a repeater or
other similar device.