Velodyne Acoustics CHT- 8Q - Manual (Page 10)

7
.
w w w . v e l o d y n e . c o m
CHT-Q Series User’s Manual
(2) SPEAKER LEVEL OUTPUT Terminals
Sends a crossed-over speaker-level signal to the front speakers. See below for a
more detailed explanation of this crossover.
(3) IR INPUT
This is a connection that allows the utilization of a third party infrared remote
sensor, such as Elan or Xantech, or an extended cable for placement closer to your
other remote controlled equipment. This keeps you from awkward control angles
using the infrared remote control.
(4) LINE OUTPUT
Connect these jacks to the LINE IN preamp input to use the DEQ-R’s internal high
pass crossover. The signal fed from these connectors is rolled off below 120 Hz.
LINE INPUT/LFE
Connect these jacks to the LINE OUT preamp output, LFE output, or subwoofer
output jacks of your receiver/processor. If using the LFE output from your receiver
or processor, plug the single cable into the “L” – LFE input or, for more signal, use
a “Y” connector (not included) and feed the signal into both “R” and “L” inputs.
(5) AUTO ON/OFF Switch
Use this switch to select between “stand-by” mode (woofer shuts off after eight
minutes) and “always on” operation.
(6) VOLUME Control
This control allows you to balance the output from the subwoofer to the main
speakers in your system. This control should be set to achieve similar volume level
from between both the main speakers and subwoofer. When pressing volume up
or down, set the level while watching the LED display for reference.
Note: Volume is also controllable by using the supplied remote. When defaults are restored,
the default is 30 out of 80.
(7) LOW-PASS CROSSOVER
Use this knob to select the frequency above which you wish to cut off the signal to
the subwoofer. When the knob is turned all the way to the left, the Subwoofer
Direct feature is invoked and the subwoofer plays all frequencies up to 120 Hz.
R e a r P a n e l C o n n e c t i o n s — D e t a i l e d E x p l a n a t i o n
Your new subwoofer is equipped with both speaker-level and line-level inputs. Use the
RCA/Phono type “INPUT” jacks when connecting your subwoofer to a pre-amp, signal
processor, or line-level crossover. The “SPEAKER LEVEL INPUT” jacks connect directly to the
speaker outputs of an integrated amplifier or receiver. Your amplifier section will notice no
additional loading effects when you use these inputs because of their high impedance.
Note:
Do not use both the RCA/Phono “INPUT” connections and “SPEAKER LEVEL INPUT”
connections simultaneously.