Cast iron stove and burner system, Sdvbn(a) and sdvbp(a), Continued – Vanguard Heating SDVBN(A) User Manual
Page 6
6
®
CAST IRON STOVE AND BURNER SYSTEM
105499
SDVBN(A) AND SDVBP(A)
CAST IRON STOVE
AND DIRECT-VENT
BURNER SYSTEM
ASSEMBLY
Continued
Figure 12 - Attaching Stove Door
Step
Bolt
Door
Hinge
Threaded
Hole
Stove
Door
Stove Bottom
Bolt
Shoulder
Adjusting Nut
Bolt Stop
Catch Bolt
Door Claw
Door
Figure 13 - Catch Bolt and Door Claw
Orientation
10. Attach stove door by inserting step bolt
through door hinge pivot hole and into
threaded hole in stove body (see Figure
12 and Figure 9 on page 5). Use an ad-
justable wrench or a 12mm socket to fas-
ten step bolt. Tighten step bolt until snug.
Make sure door moves freely.
11. Install door catch bolt (M8 x 1.25-55mm
with two M8 hex nuts) into threaded hole
on stove body (see Figure 9, page 5).
Use an adjustable wrench or a 12mm
socket. The catch bolt has two hex nuts
attached to it (see Figure 13). The top
nut is a bolt stop and the bottom nut is
for door leveling adjustment.
12. Check general catch bolt alignment
with door claw. Make final adjustment
and door leveling after stove is in nor-
mal standing position.
13. Carefully lift stove back up on its four
attached legs.
14. Set top grate into stove top.
INSTALLING DIRECT-VENT
BURNER SYSTEM INTO
STOVE BODY
1.
Carefully lift burner system and place
into stove body from the rear of stove.
2.
Using screws provided, attach burner
system to back of stove.
Figure 14 - Installing Burner System Into
Cast Iron Stove Body
LO
H
I
P
IL
O
T
OFF
ON
Cast Iron
Stove Body
Screw
Burner
System
8.
Fasten each leg to stove with four (4)
M8 x 1.25 - 20mm bolts. Use a flat
washer and lock washer with each bolt.
Tighten bolts into threaded holes on
stove body (see Figure10 and Figure 9
on page 5). Use an adjustable wrench
or a 12mm socket.
9.
Fasten stove bottom to stove with four
(4) M6 x 1 - 25mm bolts. Use a flat
washer and lock washer with each bolt.
Tighten bolts into threaded holes on
stove body (see Figure 11 and Figure 9
on page 5). Use an adjustable wrench
or a 10mm socket.
Figure 10 - Attaching Stove Legs
Bottom Of
Stove Unit
Leg
Bolt
Washers
Figure 11 - Attaching Stove Bottom
Bottom Of
Stove Unit
Bolt
Washers
Stove Bottom