Scarlett SC-1221 - Manual (Page 4)

IM010
www.scarlett.ru SC-1221 4
GB INSTRUCTION MANUAL
IMPORTANT SAFEGUARDS
• Please read these operating instructions carefully
before connecting your kettle to the power supply,
in order to avoid damage due to incorrect use.
• Before the first switching on check that the voltage
indicated on the rating label corresponds to the
mains voltage in your house.
• Incorrect operation and improper handling can lead
to malfunction of the appliance and injuries to the
user.
• For home use only. Do not use for industrial
purposes.
• Always unplug the appliance from the power supply
when not in use.
• Do not immerse the unit, cord or plug in water or
other liquids. If it has happened, remove the plug
from the wall socket immediately and have the unit
checked by an expert before using it again.
• Do not operate the appliance if the cord or the plug
is damaged or if the appliance has been otherwise
damaged. In such cases take the appliance to a
qualified specialist for check and repair if
necessary.
• Ensure that the cord does not hang over sharp
edges and keep it away from hot surfaces.
• To disconnect the appliance from the power supply
pull it out by the plug only, not by the cord.
• Place the appliance on a dry stable surface, away
from sources of heat (e.g. hotplates); do not place
it under curtains and shelves.
• Do not leave the appliance unattended when in
use.
• This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning use of the
appliances by a person responsible for their safety.
• Children should be supervised to ensure that they
do not play with the appliance.
• ATTENTION: Do not open the lid while water is
boiling.
• Close the lid properly before switching on.
Otherwise, the appliance will not switch off
automatically and the hot water may overflow.
• The kettle is for heating water only, not for any
other purposes and liquids.
• Do not press the push button with your hand!
• If the product has been exposed to temperatures
below 0ºC for some time it should be kept at room
temperature for at least 2 hours before turning it
on.
• The manufacturer reserves the right to introduce
minor changes into the product design without prior
notice, unless such changes influence significantly
the product safety, performance, and functions.
BEFORE USING FOR THE FIRST TIME
• Remove all packing materials and stickers from the
kettle.
• Fill the thermo pot with cool water up to the
maximum level mark and boil it. Empty the thermo
pot. Repeat this operation. The appliance is ready
for use.
INSTRUCTION FOR USE
FILLING
• Fill a thermo pot through a orifice in opened cover.
Do not fill with less than 0.5 l of water to prevent
the thermo pot from operating dry and do not fill
more than 3.0 l (up to “FULL” mark)
SWITCHING ON
• Place the thermo pot filled with water on a plane
surface.
• Connect the plug to the power supply. The
appliance will begin to operate and boiling indicator
will light.
KEEP WARM FUNCTION
• When the water is boiled thermo pot will
automatically switch to keep warm function. The
boiling light indicator will go off and keep warm light
indicator will go on.
• NOTE: The appliance should not be used when empty or
with less than 0.5 l of water. This may lead to a
malfunction.
RE-BOIL FUNCTION
• Keep warm function temperature is lower than boil
temperature. In case of need thermo pot allows to
boil warm water quickly. For that press the “Re-
boil” button.
WATER POURING OPTIONS
• There are three options for pouring water out of the
device:
Mechanical
• This option is available even when the device is
unplugged from the socket.
• Place the cup under the water spout.
• Press the mechanical water dispensing button
several times.
Automatic
• This option is used when the device is plugged into
the socket.
• Place the cup under the water spout.
• Press the automatic water dispensing button
“POUR OUT”.
Using the push button
• This option is used when the device is plugged into
the socket.
• Place the cup under the water spout.
• Using the cup press the push button (do not press
the push button with your hand!)
REFILL
• To prevent the thermo pot from operating dry add
water that its level in the appliance was not lower
than mark "MIN".
SWITCHING OFF
• To switch off the appliance disconnect it from the
power supply.
CARE AND CLEANING
• Open the lid and pour out the water through the
orifice.
• Always remove the plug from the socket and let the
appliance cool down completely.
• Clean the outside of the thermo pot with a soft
damp cloth, then wipe with a dry cloth. Do not use
any abrasive materials.
• Remove scale regularly, using special descaling
agents, available at the market, following given
instructions.
• Switch off and unplug the appliance; let it entirely
cool.