VTech 9116 - Manual

Parts Check List:
1. Handset
2. Base Unit
3. Telephone line cord
4. AC adapter
INTRODUCTION
IMPORTANT SAFETY INSTRUCTIONS
1. Remove the battery case by pressing
on the ridged lines and sliding
downward.
2. Discard the old battery pack. Don't put
the old battery pack in a trash
compactor or a fire - it could burst.
work is required, contact VTech Customer
Service at 1-800-595-9511. Opening or
removing cabinet parts other than specified
access doors may expose you to
dangerous voltages or other risks. Incorrect
reassembling can cause electric shock
when the appliance is subsequently used.
11. Do not overload wall outlets and extension
cords as this can result in the risk of fire or
electric shock.
12. Unplug this product from the wall outlet:
a) When the power supply cord or plug is
damaged or frayed.
b) If liquid has been spilled into the product.
c) If the product has been exposed to rain
or water.
d) If the product does not operate normally
by following the operating instructions.
Adjust only those controls that are
covered by the operating instructions
because improper adjustment of other
controls may result in damage and will
often require extensive work to restore
the product to normal operation.
e) If the product has been dropped and
the cabinet has been damaged.
f) If the product exhibits a distinct change
in performance.
13. Avoid using a telephone (other than a
cordless type) during an electrical storm.
There may be a remote risk of electric
shock from lighting.
14. Do not use the telephone to report a gas
leak in the vicinity of the leak.
SAVE THESE INSTRUCTIONS
When using your telephone equipment, basic
safety precautions should always be followed to
reduce the risk of fire, electric shock and injury
to persons, including the following:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked
on the product.
3. Unplug this product from the wall outlet before
cleaning. Do not use liquid cleaners or aerosol
cleaners. Use a damp cloth for cleaning.
4. Do not use this product near water (for
example, near a bath tub, kitchen sink, or
swimming pool).
5. Do not place this product on an unstable cart,
stand, or table. The product may fall, causing
serious damage to the product.
6. Slots and openings in the cabinet and the
back or bottom are provided for ventilation.
To protect it from overheating, these openings
must not be blocked by placing the product
on the bed, sofa, rug, or other similar surface.
This product should never be placed near or
over a radiator or heat register. This product
should not be placed in a built-in-installation
where proper ventilation is not provided.
7. This product should be operated only from
the type of power source indicated on the
marking label. If you are not sure of the type
of power supply to your home, consult your
dealer or local power company.
8. Do not allow anything to rest on the power
cord. Do not locate this product where the
cord will be abused by persons walking on it.
9. Never push objects of any kind into this
product through cabinet slots as they may
touch dangerous voltage points or short out
parts that could result in a risk of fire or electric
shock. Never spill liquid of any kind on the
product.
10. To reduce the risk of electric shock, do not
disassemble this product. If service or repair
IMPORTANT: Do not dispose of this battery
in household garbage. For
information on recycling or
proper disposal, consult
your local solid waste
collection or disposal
organization.
3. Hold the battery pack and plug the cord
into the handset. (The two cord metal
tips on the white plastic end of the plug
should be facing upwards.) Place the
cord in the case so it rests on top of the
battery pack.
4. Replace the battery cover by sliding it
into place.
5. The new battery pack must be charged
before using your telephone. Place the
handset in the cradle of the base unit to
allow it to charge for 24 hours. Maximum
battery life between charges is more
than 5 hours of continuous talk time or
4 days of standby.
CAUTION: To reduce the Risk of Fire or
Injury to Persons, Read and
Follow these instructions:
1. Use only VTECH battery.
1
3 2
REPLACING THE HANDSET BATTERIES
5. Battery Pack
6. Wall mounting bracket
7. Belt Clip
2. Do not open or mutilate the battery.
Released electrolyte is corrosive and
may cause damage to the eyes or
skin. It may be toxic if swallowed.
3. Exercise care in handling batteries in
order not to short the battery with
conducting materials such as rings,
bracelets, and keys. The battery or
conductor may overheat and cause
burns.
4. Do not dispose of the battery in a fire.
The cell may explode.
TELEPHONE LINE
CORD
WALL MOUNTING
BRACKET
BASE UNIT HANDSET
AC ADAPTER
BATTERY PACK
BELT CLIP
PAGE
CHARGING
VTECH
VTECH TELECOMMUNICATIONS LTD
Printed in China 91-5141-11-00 ISSUED 0
To help protect the environment, this
product may contain recycled or
reconditioned parts and materials.
MHz
USER’S MANUAL
HEADSET CAPABLE (2.5mm) 900MHz HIGH FREQUENCY