VTech 9126 User Manual
Page 19
19
A
D
V
ANCED OPERA
TION
OPTIONAL HEADSET INSTALLATION &
OPERATING INSTRUCTIONS
Your
VT 9123/9126 cordless telephone is equipped with a 2.5mm Headset Jack for use with
an
optional accessory Headset for hands-free operation.
If you choose to use the Headset option, you must do the following:
INSTALLATION
* Obtain an optional accessory Head set, which is com-
patible with the
VT 9123/9126.
Please contact VTECH Communications Customer
Service, in the U.S. toll-free at 1-800-595-9511, in the
Canada call 1-800-267-7377 for dealer information in
your local area. You can also purchase a compatible
Headset directly from VTECH Communications Cus-
tomer Service.
* Once you have a compatible 2.5mm Headset, locate
the Headset Jack on the Handset of your
VT 9123.
Connect the plug on the Headset to the jack on the
cordless Handset. The plug should fit securely. Do not
force the connection. See illustration.
OPERATION
NOTE: Whenever a compatible Headset is connected to the cordless Handset, the micro-
phone on the Handset will be MUTED. This is done to limit the effect of background noise.
*
The following operational characteristics apply to VTECH Headsets. the same may also
apply to other (non-VTECH) compatible headsets, but VTECH assumes no responsibility
for their performance.
*
The VTECH brand compatible Headset has a monaural design which is reversible, so you
can wear your Headset on either the left or right ear, leaving one ear free for room
conversation.
*
The headband can be adjusted to fit the contour of your
head. Using both hands, slide the headband up or down
so that it rests comfortably on your head with the speaker
cushion centered against your ear.
*
For maximum sound quality, the flexible microphone
should be positioned at the corner of your mouth, about
one inch from your mouth.
BELT CLIP
*
The
VT 9123/9126 is also equipped with a detachable
belt clip. Align the pins on the inside edge of the belt clip
with the notches on the side of the
VT 9123/9126 hand-
set. The belt clip should snap securely into place. Do
not force the connection. See Illustration.