Operation – Weed Eater Twist 'N Edge 530163438 User Manual

Page 4

Advertising
background image

4

1.

Remove wing nut from shield.

2.

Insert bracket into slot as shown.

3.

Pivot shield until bolt passes through hole in
bracket.

4.

Securely tighten wing nut onto bolt.

Slot

Shield

Wing
Nut

Bracket

Line Limiter Blade

OPERATION

KNOW YOUR TRIMMER

READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT.

Compare the illustrations with your unit to familiarize yourself with the location of the various controls

and adjustments. Save this manual for future reference.

Line Limiter
Blade

Primer Bulb

Fuel Mix
Fill Cap

Assist Handle

Starter
Handle

ON/STOP
Switch

Throttle Trigger

Choke Lever

Spark Plug

Shield

Trimmer
Head

Tube

Muffler

Edge
Guide

ON/STOP SWITCH

The ON/STOP switch is used to stop engine. To
stop the engine, push and release the engine
ON/STOP switch.

PRIMER BULB

The PRIMER BULB removes air from the car-
buretor and fuel lines and fills them with fuel.
This allows you to start the engine with fewer
pulls on the starter rope. Activate the primer
bulb by pressing it and allowing it to return to
its original form.

CHOKE

The CHOKE helps to supply fuel to the engine
to aid in cold starting. Activate the choke by
moving the choke lever to the FULL CHOKE
position. After the engine attempts to start, move
the choke lever to the HALF CHOKE position.
Once engine has started, move the choke lever
to the OFF CHOKE position.

BEFORE STARTING ENGINE

WARNING:

Be sure to read the fuel

information in the safety rules before you
begin. If you do not understand the safety
rules, do not attempt to fuel your unit. Call
1-800-554-6723.

FUELING ENGINE

WARNING:

Remove fuel cap slowly

when refueling.
This engine is certified to operate on unleaded
gasoline. Before operation, gasoline must be

mixed with a good quality synthetic 2-cycle
air-cooled engine oil designed to be mixed at a
ratio of 40:1. Poulan/Weed Eater brand
synthetic oil is recommended. Mix gasoline and
oil at a ratio of 40:1. A 40:1 ratio is obtained by
mixing 3.2 ounces (95 ml) of oil with 1 gallon (4
liters) of unleaded gasoline. DO NOT USE
automotive oil or boat oil. These oils will cause
engine damage. When mixing fuel, follow
instructions printed on container. Once oil is
added to gasoline, shake container momentarily
to assure that the fuel is thoroughly mixed.
Always read and follow the safety rules relating
to fuel before fueling your unit.

Advertising