Westinghouse W-261 - Manual (Page 4)

4
CAUTION: For fixtures labeled for outdoor and wet location use, provide a water-tight seal
between the fixture and the mounting surface by using silicone or similar caulking.
NOTE: Underwriters Laboratories (UL) does not require all fixtures to have ground wires. These
fixtures meet all UL specifications.
1. Turn off power at circuit box to avoid possible electric shock.
NOTE: If post does not have mounting holes, follow step 2. Otherwise skip step 2 and proceed
with step 3.
2. Place fitter (A) over post (B). Mark post (B) using fitter holes as guide. Remove fitter (A),
drill 1/8” hole into post (B) at each mark.
3. Pull wires up from post (B) and thread through fitter (A).
4. Identify color coding of fixture wires (see figure 2).
5. To connect wires, take black fixture wire (group A from fig. 2) and place evenly against
black post wire. Do not twist wires.
6. Fit wire connector (C from figure 1) over wires and twist until there is a firm connection. If
wire connector (C) easily comes off, reattach and check again for a firm connection.
7. Repeat steps 5 and 6 with the white (group B from fig. 2) fixture wire and white post wire.
8. Place ground wire from fixture evenly against ground wire (metal or green wire) from post (B).
9. Repeat step 6 for ground wires.
MOUNTING AND WIRING INSTRUCTIONS
FIXTURE ASSEMBLY INSTRUCTIONS
1. Place fitter (A) over post (B) (see figure 1).
2. Secure with mounting screws (D).
3. Remove screws (E) from cover (F) and remove cover (F).
4. Install lamp(s) (G) into socket base (H).
5. Replace cover (F) and secure with screws (E).
6. Turn power back on at circuit box.
Fixture includes photocell which turns on at dusk and off at dawn, and cannot be disabled.
12 pg_W-261_EFS 5/16/06 10:38 PM Page 4