Walker W300 - Manual (Page 16)

Walker W300 16
2. Pick up the handset and listen for the
caller’s voice or a dial tone. Watch the
green sound level light located on the
phone base, next to the program button.
It should sign steady.
3. When placing a call, dial as you
would any phone and wait for someone
to answer.
4. Press the Boost Button
5. Adjust the Clarity ® Power Control TM
upwards to a level where the other
party’s voice is heard loud and clear,
and begin conversation.
6. When you complete the call, return
the handset.
7. After hanging up, the sound level will
reset according to the position of the reset
switch on the back of the telephone. See
Boost Override.
8. Pressing the Boost Button during
subsequent conversations will return the
volume to your set sound level.
Note: If you made an error while dialing,
just depress the hookswitch, listen for a
dial tone, and dial again.
➤ Backlite Keypad
The keypad features large translusent
back lite buttons that will make calling
easier.
➤ Nite Lite
The Nite Lite feature illuminates the key
pad and 3 extra large storage buttons.
The Nite Lite makes the keypad visable
when the phone is hung up, allowing it to
be easily located at night. The Nite Lite
can be adjusted to OFF, LO and HIGH.
➤ Neck Loop/Auxillary Port
The W300 has a 3.5mm phono jack to use
with a neck loop. The volume to the neck
loop is controlled with the Clarity Power
Control. When the neck loop is plugged in,
the receiver in the handset is disabled.
Once you have installed your Walker
W300 according to the instructions noted
previously, it will be ready to use.
➤ To Place or Receive a Call:
1. Adjust the Clarity ® Power Control TM to
its lowest setting (zero).
WALKER W300 FEATURES
W300_UGD_REVD_7.29.02 8/1/02, 6:29 AM 16