Wolfcraft QUICK JAW 6134 - Manual (Page 5)

5
Folding Your Workbench
1. Remove any hand tools or parts from table top and
storage rack.
2. Carefully pull up on hinges, with fingers under
hinge flange, to unlock hinges.
3. Tilt Stand back slightly onto rear legs.
(See Figure 4.)
4. Reach down and push front legs backward.
Figure 4
Opening the Workbench
1. Standing at rear of workbench, grasp front edge of
table top and underside of rear cross brace.
2. Pull rear cross brace toward you while
simultaneously pulling up on table top.
3. When fully open, secure in locked position by
pushing on hinges until completely down.
To Adjust Table Top Jaw
Turn the front table top jaw adjustment handles
counterclockwise to move front jaw toward you. Turn
adjustment handles clockwise to move front jaw
away. (See Figure 5.) The table top jaws open to
clamp a maximum 7-inch wide workpiece.
Adjusting Jaw to Angle
Workbench jaw adjusts to a maximum angle of 14
degrees for clamping irregular shaped workpieces.
To adjust jaw to angle, turn either the right or left
adjustment handle until desired angle is reached.
WOLF112-3
Figure 5
Using Adjustable Swivel Pegs – Figure 6
Your workbench is equipped with 4 swivel pegs
[R, page 3]. The swivel pegs can be positioned into
any of the holes in the front and rear of top for
gripping irregular shaped workpieces, or to extend
gripping and clamping when the workpiece exceeds
the jaw capacity.
Swivel pegs are to be used to grip
workpiece only in cases where the workpiece DOES
NOT extend beyond the surface of the jaw.
Figure 6
WOLF112-5
WOLF112-4
CAUTION