One 2 one, Fm receiver, Model r1-216 – Williams Sound One 2 One R1-216 User Manual
Page 2
ONE 2 ONE
™
FM Receiver
•
Model R1-216
ONE 2 ONE
™
FM Receiver •
Model R1-216
©2007, Williams Sound Corp. MCAT 013C
2
Bid Specs:
The PPA R1-216 receiver shall be housed in an impact resistant plastic case with a hinged battery door
that does not separate from the receiver. The receivers shall be a body-pack type and include a belt-clip
case for hands-free operation. The receiver shall have a 3.5 mm mono phone jack and accommodate low-
impedance mono earphones, headphones and neckloop telecoil couplers. It shall have drop-in charging
points on the bottom of the unit. Receiver frequencies shall be pre-tuned and adjustable by means of an
internal tuning coil. A four-channel receiver model shall be available for use with the system. The
receivers shall receive FM signals in the 216 MHz bandwidth with 100 µS de-emphasis. The receivers shall
provide a maximum output of 35 mW at 16 Ohms with an earbud-type earphone. The system electrical
frequency response shall be 200 Hz to 10 kHz P-P, +2, -4 dB and the signal-to-noise ratio shall be 60 dB at
10 µV. The receiver shall have FCC and WEEE approval and be covered by a five-year parts and labor war-
ranty.* The receiver model shall be the Williams Sound Corp. model PPA R1-216.
NOTE: SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE!
*90 days on accessories.