Wasp Bar Code WWS850 - Manual (Page 16)

27
Update
• Max / Min Code Length Qualification
Select Max / Min Length Qualification
Max Length *
Min Length *
• Fixed Code Length Qualification
Select Fixed Length Qualification
Fixed Length 1 *
Fixed Length 2 *
Programming Instructions: (1) Read the label. (2) Program the desired length
by reading Decimal Digits on page 53. (3) Read the “Validate” label (also on
page 53) to complete this setting.
Interleave 25 Parameters Interleave 25 Parameters Interleave 25 Parameters Interleave 25 Parameters
• Start / Stop Selection
Industrial 25
< Interleave 25 >
Matrix 25
28
Enter Setup
• Checksum Verification
Enable
< Disable >
• Checksum Transmission
< Enable >
Disable
• Max / Min Code Length Qualification
Select Max / Min Length Qualification
Max Length *
Min Length *
Programming Instructions: (1) Read the label. (2) Program the desired length by
reading Decimal Digits on page 53. (3) Read the “Validate” label (also on page
53) to complete this setting.