Waterford Precision Cycles Built-in 70 - Manual (Page 8)

secure with three screws (10) to the upper wall
(Fig.4a)
Fit the sealing strip 6 between the bottom of the
appliance and the floor of the cabinet.
Secure to the cabinet floor with screws 10 and
insert the caps 14 (Fig.4b).
Screw the adjusting screws 7 in the two threaded
holes located on the upper edge of the freezer door
(Fig.5).
Freezer Door
Put the cabinet door flat, front side down, mark two
points in the centre of bean openings using the pat-
tern 4 (Fig.6).
Loosely fasten the fastening strip 1 to the cabinet
door with two screws 10 at the marked points
(Fig.6a).
Put the cabinet door on the freezer door and centre
it.
Take off the cabinet door and secure the fastening
strip 1 with four screws 10 and fully screw the
screws located at the bean openings (Fig.6b)
Mount the cabinet door panel onto the freezer door
(Fig.7)
With a Philip’s head screwdriver, adjust the door
position by screwing or unscrewing the adjusting
screw 7 so as the cabinet door is level with the cab-
inet.
Secure the cabinet door position by fitting the angle
bars 3 to the lower edge of the freezer door using
one screw 12 and to the cabinet door with two
screws 10 (Fig.8a).
Fridge Door
Repeat operations for the freezer door but using
the dimensions given in Fig.9 as well as pattern 4.
Insert the decorative cover panel 2 on the adjusting
strip 1 (Fig.10)
Parts List
7