WindChaser Products PACR9 - Manual (Page 9)

TIMER PROGRAMMING
1. To set the Shut-Off Timer on the unit, make sure the unit is on, then press the TIMER
SETTING button on the control panel or the ( ) button on the remote control .
2. Press the ( ) button on the remote or the (+) button on the control panel to set the
desired time. If the setting is higher than desired, press the ( ) on the remote control
or the (-) on the control panel to lower the time.
3. Finally press the ( ) button on the remote or the “TIME SETING” button on the control
panel to enter the selected off time to finalize the setting.
4. To activate the ON Timer, follow the instructions above, but the unit must be turned off first.
DEHUMIDIFICATION OPERATION
Press the “MODE” button on the control panel or ( ) button on the remote to select the dehumidifier
mode. When the dehumidifier mode is on, the temperature buttons and the fan speed buttons do not
function and the fan will operate on low speed. The dehumidifier indicator light will illuminate and stay
solid while the unit is dehumidifying. When the humidity in the room is 50% or lower, the compressor will
not run, the unit will not dehumidify, and the dehumidifier light will blink. Remember, the exhaust hose
does not need to be used in dehumidifier mode.
a)
b)
c)
d)
e)
f)
g)
a) LCD Screen
b) Power ON/OFF Button
c) Timer and Thermostat Setting Buttons
d) Mode Button
(Select A/C, Fan or Dehumidifier)
e) A/C Fan Speed Button
(High, Medium or Low)
f) Timer ON/OFF Button
g) Fahrenheit / Celcius Selector
7