Well Traveled Living Stowe - Manual (Page 4)

CONTROLS/LEG ASSEMBLY
Your fireplace has the following functions: Leg Assembly:
Lay stove on a flat surface. Attach 4 legs
with screws provided as shown in Fig. 1:
FOR YOUR SAFETY
Service must be performed by a qualified service agency.
REPLACING THE LIGHT BULBS
This fireplace uses 2 clear 110 Volt, 40 Watt, E-12 socket base light bulbs (small base,
chandelier candle type bulbs). The access plate is located on the back of the unit. For
convenience, if one of the light bulbs burns out, it may be easier to replace both of the
light bulbs at the same time.
WARNING: Do not exceed 40 Watts per bulb. Use of higher rated bulbs may result in a
fire, causing property damage, personal injury or loss of life.
1. Turn off the power to the unit, and unplug it from the electrical outlet.
2. Let the fireplace cool if it has been operating.
FIG 1 FIG 2
Low heat
700 watts
On/Off
Power to the unit
High heat
1350 watts
Please note: Both the low heat and high heat
switches must be in the on position to achieve
high heat.
Fig. 1