Waves Plug-in for Vocals and Monophonic - Manual (Page 12)

The corrected pitch graph may be further edited using a few simple tools that change the
appearance of the mouse pointer in context with its current function.
Undo/Redo
Next to the Graphic Tools section are the Undo/Redo buttons. These pull-down menus
allow you to view and access any point of the Undo/Redo history, up to 32 levels deep.
Position window
The Position Window, located at the bottom-right of the Pitch Graph, shows you the note
and cents of the note at the current cursor location.
V
IBRATO
S
ECTION
On the lower-right corner of the Tune interface is the Vibrato Section. Two vibrato types
are available: Synthetic and Natural.
The Natural Vibrato section has the following controls:
On/Off - Turns Natural Vibrato manipulation on/off (Please note that in order to
manioulate natural vibrato you first need to detect it by turning vibrato segmentation to
on in places where you suspect there is a natural vib.
When selected, you will be able to manipulate the Natural vibrato in places where it was
detected. The Natural Vibrato will perform a new segmentation only when the Vibrato
button in the segmentation section is turned on.
Amount: 0% to 200%; Default: 100%
This is a ratio multiplier for the detected natural vibrato. At 0, the Tune will
flatten the Natural Vibrato and at 200% it will double the amount of the natural vibrato.
Attack:
This is the time it will take the natural vibrato modulation to build to its full
assigned amount.
The Synthetic Vibrato section has the following controls:
On/Off button (in the Vibrato section) – Turns Synthetic Vibrato on/off.