Whirlpool 2218585 - Manual (Page 13)

13
Removing and replacing the shelf track
1. Remove the shelf track by lifting both sides of the track
slightly and pulling the track straight out.
2. Replace the track by guiding the track hooks into the shelf
support slots on the back wall.
NOTE: Make sure that both sets of track hooks are in the
slots and that the slots are parallel with each other.
3. Push the track back and down securely into the shelf
supports.
Replacing the shelf
NOTE: Make sure that both of the rear shelf slides are securely in
the track before letting go of the shelf. The lateral shelf may be
difficult to install if the track is placed too close to the refrigerator
ceiling. Reposition the track on a lower rung until the shelf can be
tilted enough to easily slide into the track.
1. Hold the shelf at the front and tip the front at a 45˚ angle to
the track.
2. Insert both of the rear shelf slides into the upper channel of
the track, and lower the front of the shelf into place.
Crispers and Meat Drawers
(on some models)
Drawers
Removing and replacing a drawer
1. Slide drawer straight out to the stop. Lift the front of the
drawer and slide it out the rest of the way.
2. Replace a drawer by sliding it back in fully past the stop.
Crisper Cover
Removing the crisper(s) cover
1. Remove crisper(s). Hold the glass insert firmly with one hand
and press up in the center of the glass insert until it rises
above the plastic frame. Carefully slide the glass insert
forward to remove.
2. Lift the cover frame and remove it.
Replacing the crisper cover
NOTE: Before reinstalling the cover, make sure the
U-shaped reinforcement bar is reinstalled in the front edge of the
crisper cover.
1. Fit back of cover frame into supports on side walls of the
refrigerator and lower the front of the cover frame into place.
2. Slide rear of glass insert into cover frame and lower front into
place.
Meat Drawer Cover
Removing and replacing the meat drawer cover (Style 1
glass)
1. Remove the meat drawer. Tilt up the front of the cover and lift
at the back. Pull the cover straight out.
2. Replace the cover by guiding the rear hooks into the shelf
supports. Tilt the cover up at the front until the rear hooks
drop into the slots. Lower the front of the cover to a level
position and replace the meat drawer.
Removing and replacing the meat drawer cover (Style 2
plastic)
1. Remove the meat drawer. Tilt the cover up at the front and
pull it forward and out.
2. Replace the meat drawer cover by fitting the notches and rear
edge of the cover over rear and center crossbars on the shelf.
Lower cover into place and replace the meat drawer.
Crisper Humidity Control
(on some models)
You can adjust the amount of humidity in the moisture-sealed
crisper using the settings between HIGH and LOW.
■ LOW (open) lets moist air out of the crisper for best storage of
fruits and vegetables with skins. Fruit: Wash, let dry and store
in refrigerator in plastic bag in crisper. Do not wash or hull
berries until they are ready to use. Sort and keep berries in
original container in crisper. Vegetables with skins: Place in
plastic bag or plastic container and store in crisper.
■ HIGH (closed) keeps moist air in the crisper for best storage
of fresh, leafy vegetables. Leafy vegetables: Wash in cold
water, drain and trim or tear off bruised and discolored areas.
Place in plastic bag or plastic container and store in crisper.
Humidity control location
■ Humidity Control on crisper drawer (Style 1 - on left/Style 2 -
on right)