Wharfedale 35 - Manual (Page 2)

APPLICATION: Wharfedale Pro Programme 35 & 35T series of
foreground/background music speakers designed for demanding
professional applications such as the reproduction and
reinforcement of music and sound in
venues as diverse
airports, places of worship, retail premises, restaurants and
public houses.
DESCRIPTION: Programme 35 & 35T Black/Rosewood Two-way
(6.5” /165 mm woofer and 1”/25.4mm metal dome tweeter) reflex
vented acoustically-efficient enclosure.
DEPLOYMENT: The Programme 35 & 35T can be mounted in a
vertical or horizontal position using the mounting bracket
hardware. All models have been designed for table-top or
bookshelf installation or, with the use of special accessories they
can be installed on the wall or Ceiling mounted.
IMPORTANT NOTE See Warning Section on RIGGING •
SUSPENDING • MOUNTING before attempting to install
Wharfedale Pro Programme 35 & 35T series of speakers.
Optional Brackets are available from Wharfedale.
H I G H - I M P E D A N C E / C O N S T A N T - V O L T A G E S Y S T E M :
The Programme 35T features an internal line-matching
transformer with four power/impedance selections for 100 volt line.
When speaker systems are connected in series, anything over
32
Ω
is considered high impedance. Use of constant-voltage
distribution in installation increases the impedance to the desired
level at the speaker location. With the line impedance well above
the nominal speaker impedance, power loss in long speaker lines
is minimised. Smaller wire can be used without excessive power
loss.The four switchable power tappings are 5W,10W, 20W and
40W
HF PROTECTION:The Programme 35 & 35T series speakers are
equipped with the “PRO-TECH”™ system, a dynamic tweeter
protection circuit, composed of an accurate and sensitive
protection lamp. When high signal levels are present that may
pose a dangerous overload for the tweeter coil, the protection
circuit will activate immediately to limit the power sent to the
transducer.
PROGRAMME 35 & 35T SERIES
TECHNICAL SPECIFICATION
MODEL
LF Driver
HF drive unit
HF driver protection
Power Handling
Music/Peak
Nominal Impedance
Sensitivity
SPL (peak)
Frequency
Response
Cabinet finish
Crossover point
Weight (single unit)
Dispersion character
Input connector
Dimension (mm & ins)
H x W x D
Enclosure type
Program 35
6.5”/ 165 mm x 1
25.4mm aluminised
mylar Dome
Polyswitch
60W/120W
8
Ω
88dB 1w @1m
108db
50Hz-20kHz
Black/Rosewood
2.3kHz
5.3Kg / 11.6 lbs
60x60
Bare wire connector
310x220x203mm
12.2 x 8.7 x 8 inches
2 way reflex
Program 35T
6.5”/ 165mm x 1
25.4mm aluminised
mylar Dome
Polyswitch
100V line
5/10/20/40W
-
-
-
50Hz- 20kHz
Black/Rosewood
2.3kHz
6.7Kg / 14.7 lbs
60x60
Bare wire connector
310x220x203mm
12.2 x 8.7 x 8 inches
2 way reflex
P R O G R A M M E 3 5 & 3 5 T L O U D S P E A K E R
Wharfedale International Limited, IAG House, Sovereign Court, Ermine Business Park, Huntingdon, Cambs, PE29 6XU, England
www.wharfedalepro.com
The information in this manual is subject to change without notice. All rights reserved © 2001Wharfedale Pro.Wharfedale is a member of the International Audio Group (IAG)
911.376
A
C
B
D
E
F
G
A: 160mm
B: 138mm
C: 102mm
D: 15.5mm
E: 34.5mm
F: 101.5mm
G: 113.5mm